Common mistakes when building a wine cellar
Most wine cellar problems originate not in the cooling unit but in the preparation of the space: interrupted or inadequate insulation, warm air with nowhere to go, too much glass and an underestimated condensate drain. All of these mistakes can be avoided at the design stage.
01
Twelve mistakes and how to avoid them
- Choosing a cooling unit by maximum volume alone. The maximum volume applies only with insulation to the manufacturer’s specification. Glass, warm surroundings and weaker insulation call for a more powerful unit.
- Insulation without a design. Heat finds the weakest point – often the ceiling, the door or a wall adjoining a heated room. The build-up needs to be designed for the specific building. For Wine Master cooling units, the manual also makes the warranty conditional on insulating all surfaces according to the manufacturer’s table.
- Mineral wool as insulation. It absorbs moisture and loses its insulating capacity. EPS, XPS or PUR are suitable.
- Leaky joints and penetrations. Warm, humid air from the house gets into the structure. Tape the joints or use tongue-and-groove boards, seal penetrations, and design the build-up and moisture control for the specific construction.
- Warm air exhausted into a small unventilated room. The room overheats above 35 °C, the cooling unit loses capacity and the compressor wears out.
- Large glazed areas without high-quality glazing. The glass mists up and the cooling unit cannot keep pace. For SP40 split units, the manufacturer assumes Ug ≤ 1.0 W/m²K and glass covering no more than half the wall area.
- Heat sources in the cellar. A wine cabinet, freezer, uninsulated heating pipes, underfloor heating or halogen lights add heat that nobody allowed for.
- Condensate with no drain or no access. A blocked or kinked hose causes leaks. The drain must be accessible for inspection.
- Racks that obstruct airflow. A blocked cooling unit outlet creates warm and cold zones. The outlet must not point into a rack or into a corner.
- A cooling unit with no service access. The filter must be changed at least once a year. A unit walled in without an access panel is a problem.
- Underestimating floor load-bearing capacity. Full racks weigh hundreds of kilograms; any insulation beneath them must have sufficient compressive strength.
- Relying on a passive cellar without measuring. Before you put your collection in the cellar, measure temperature and humidity over at least a summer and a winter.
We draw on cooling unit manufacturers’ requirements and the general principles of building physics. The specific solution is always determined by the design for the particular space.
03
Sources
Technical data are based on the manufacturer’s current documentation: winemaster.fr and Wine Master manuals (IN25 X, version 07/2025, SP40 CA PRO, version 07/2025, SP40 DU PRO, version 14/2025). All manuals are available in the Documents section. The values are the manufacturer’s minimum requirements and do not replace a design for a specific building.
04 / Related
Continue
Enquiry
Send us a photograph of your space.
A short description, dimensions or a floor plan is enough for an initial assessment. We usually reply within one working day.